'************************
'Header file for 18F2620    64k Program memory
' experimental - copied from the 18F2525 file
'************************
Device = 18F2620
$define _Positron
Declare Optimiser_Level = 3                  ' Full optimisation
Declare Dead_Code_Remove = On        '/Off
Declare ICD_Req = 1                  ' to allow ICD programming and PICkit2
                                     ' params: On or Off, or True or False, or 1, 0
                                     ' note that the ICD uses pins RB5, RB6, RB7
Declare Create_Coff = 1              ' generate a .COF file for the debugger in MPLAB
Declare Xtal = 40                    ' 10MHz Xtal * 4 PLL
Declare HPWM1_Pin = PORTC.2
Declare HPWM2_Pin = PORTC.1
Symbol PWMminF = 2442                ' lowest possible pwm frequency.
Declare Unsigned_Dwords = On         ' added 11.06.2015

' configuration for 18F2620:
Config_Start
Debug = OFF  ' Background debugger disabled; RB6/RB7 configured as I/O
XINST = OFF  ' Instruction set extension mode disabled  (only required for improved float support]
STVREN = OFF  ' Reset on stack overflow/underflow disabled or enabled
FCMEN = OFF   ' was Off, changed by gwr.   ' Fail-Safe Clock Monitor disabled  - makes no apparent difference
             ' Johannes had it OFF
OSC = HSPLL  ' PLL active to set clock to 4x Xtal freq..
IESO = OFF   ' Two-Speed Start-up disabled
WDT = OFF    ' no watchdog timer
WDTPS = 128  ' Watchdog oscillator prescaler 1:128   , Johannes had it = 1
BOREN = SBORDIS   ' was off, changed to on by gwr  ' off= Brown-out Reset disabled in hardware and software
              'Johannes had it set to ON
BORV = 2     ' brown out voltage
MCLRE = On   ' MCLR pin enabled, RE3 input pin disabled
LPT1OSC = On ' Timer1 operates in standard power mode , Johannes had it ON
PBADEN = OFF ' PORTB<4:0> pins are configured as digital I/O on Reset
CCP2MX = PORTC ' CCP2 input/output is multiplexed with RC1
LVP = OFF    ' On     ' Single-Supply ICSP enabled/disabled , Johannes had it Off
Cp0 = OFF    ' Block 0 (000800-001FFFh) not code-protected
CP1 = OFF    ' Block 1 (002000-003FFFh) not code-protected
CPB = OFF    ' Boot block (000000-0007FFh) not code-protected
CPD = OFF    ' Data EEPROM not code-protected
WRT0 = OFF   ' Block 0 (000800-001FFFh) not write-protected
WRT1 = OFF   ' Block 1 (002000-003FFFh) not write-protected
WRTB = OFF   ' Boot block (000000-0007FFh) not write-protected
WRTC = OFF   ' Config registers (300000-3000FFh) not write-protected
WRTD = OFF   ' Data EEPROM not write-protected
EBTR0 = OFF  ' Block 0 (000800-001FFFh) not protected from table reads
             ' executed in other blocks
EBTR1 = OFF  ' Block 1 (002000-003FFFh) not protected from table reads
             ' executed in other blocks
EBTRB = OFF  ' Boot block (000000-0007FFh) not protected from reads
             ' executed in other blocks
PWRT = On    ' power up timer (66ms)
Config_End